To Replace The Lower Task Light - Datex-Ohmeda S/5 Avance Technical Reference Manual

S/5 Avance
9.20.3 To replace
the lower task
light
Note
9-48
1. Remove the rear panel (Section 9.2.1).
The lower task light is located directly below the MGAS partition. It slides into two
slots in the front bezel (A) and is retained with a small moveable bracket (B).
A
2. Rotate the retaining bracket counterclockwise to free the tack light assembly.
3. Disconnect the harness from the task light assembly and connect it to the new task
light.
4. Place the task light into the slots (lights pointing down).
If the machine includes an integrated suction regulator, it may be too cramped for you
to place the task light. Use long-nose pliers or a similar tool to guide the task light in
place, being careful not to damage the lights. Or you can temporarily remove the
suction regulator to gain more room.
5. Rotate the bracket in place to retain the task light.
6. Reassemble in reverse order.
B
11/03 1009-0357-000
A