Datex-Ohmeda S/5 Avance Technical Reference Manual page 237

Note
1009-0357-000 11/03
The valve body, o-ring, and flapper do not come out with the block. They stay intact at
the bottom of the vaporizer manifold.
6. Pull the flapper out of the valve body.
O-ring
Valve body
Flapper
Valve body
O-ring
Flapper
7. Using a hex wrench, put the wrench through one of the holes of the valve body and
pull down to remove the valve body and o-ring.
8. Verify that parts are free of dust and dirt.
9. Replace the flapper by inserting the flapper stem and gently pulling the stem until
the flapper secures to the valve body.
10. Lightly lubricate the o-ring with Krytox.
11. Place the lubricated o-ring on the valve body port at the bottom of the manifold.
12. Gently install the valve body in the manifold:
• Check that the o-ring makes a good seal between the manifold and the valve
body.
• Check that the flapper valve makes solid contact with the valve body.
13. Install the valve block.
14. Reconnect the tubing to the valve block. Pull on the tube to ensure that it is locked
in the fitting.
15. Install the vaporizer front panel.
16. Perform the checkout procedure (Section 3).
9 Repair Procedures
9-35