Table of Contents
Advertisement
Quick Links
Datex-Ohmeda Inc.
3030 Ohmeda Drive
53707-7550 MADISON, WIS
USA
Tel. +1-608-221 1551, Fax +1-608-222 9147
www.us.datex-ohmeda.com
TM
AS/3
Command Board, K-ANE (Rev. 02)
TM
CS/3
Command Board, K-ICU (Rev. 02)
TM
S/5
Command Bar, K-ANEB (Rev. 00)
TM
S/5
Command Bar, K-ICUB (Rev. 00)
TM
S/5
Remote Controller, K-REMCO (Rev. 01)
Datex-Ohmeda
Technical Reference Manual
All specifications are subject to change without notice.
Tel. +358 10 394 11 Fax +358 9 146 3310
Instrumentarium Corp. All rights reserved.
Document No. 8001589-1
June 2001
Datex-Ohmeda Division,
Instrumentarium Corp.
P.O. Box 900, FIN-00031
DATEX-OHMEDA, FINLAND
www.datex-ohmeda.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Datex-Ohmeda AS/3 K-ANE
Summary of Contents for Datex-Ohmeda AS/3 K-ANE
- Page 1 Command Bar, K-ICUB (Rev. 00) Remote Controller, K-REMCO (Rev. 01) Technical Reference Manual All specifications are subject to change without notice. Document No. 8001589-1 June 2001 Datex-Ohmeda Inc. Datex-Ohmeda Division, 3030 Ohmeda Drive Instrumentarium Corp. 53707-7550 MADISON, WIS P.O. Box 900, FIN-00031 DATEX-OHMEDA, FINLAND Tel.
-
Page 3: Table Of Contents
Table of contents TABLE OF CONTENTS Command Boards / Bars, Remote Controller TABLE OF CONTENTS Introduction Specifications 1.1 Command Board, K-ANE/K-ICU ........................2 1.2 Command Bar, K-ANEB/K-ICUB ........................2 1.3 Remote Controller, K-REMCO ........................2 Functional Description 2.1 Command Boards, K-ANE/K-ICU and Command Bars, K-ANEB/ K-ICUB .............3 2.1.1 Connectors and signals ........................4 2.2 Remote Controller, K-REMCO ........................5 Service procedures... - Page 4 S/5 Keyboards 6.4.4 Front panel stickers for K-ANEB/ICUB .....................21 Earlier Revisions APPENDICES A, B Service check form Command Board, K-ANE/K-ICU, Command Bar, K-ANEB/K-ICUB ........A-1 Service check form Remote Controller, K-REMCO ...................B-1 Document No. 8001589-1...
-
Page 5: Introduction
Command Boards / Bars, Remote Controller INTRODUCTION This section provides information about the maintenance and service of the following products: Command Boards, K-ANE/ K-ICU, • Command Bars, K-ANEB/ K-ICUB • Remote Controller, K-REMCO • Document No. 8001589 -1... -
Page 6: Specifications
S/5 Keyboards SPECIFICATIONS 1.1 Command Board, K-ANE/K-ICU Dimensions, W × D × H 315 × 55 × 43 mm Weight (incl. cable) 0.5 kg Input voltage Power consumption 450 mW max Communication protocol RS-232 NOTE: Power supply from the display controller board only. 1.2 Command Bar, K-ANEB/K-ICUB Dimensions, W ×... -
Page 7: Functional Description
Command Boards / Bars, Remote Controller FUNCTIONAL DESCRIPTION 2.1 Command Boards, K-ANE/K-ICU and Command Bars, K-ANEB/ K-ICUB KEYBOARD PCB COMWHEEL 5 PIN DIN (D-LCC10) CONNECTOR DISPLAY CONTROLLER RS-232 BOARD PROGRAM MEMORY EPROM KEYBOARD KEYBOARD SCANNING CIRCUIT ALARM LEDS STBY DISPLAY ON/STBY CONTROLLER SWITCH... -
Page 8: Connectors And Signals
S/5 Keyboards LEDs The alarm LEDs are activated by the Command Board/Bar PCB under the commands received via serial communication from the CPU board. The red or yellow alarm LED is lit when red or yellow alarm is activated. STBY -led is lit when the device is turned to stand-by and connected to mains. NOTE: If there are two Command Boards/Bars connected to the system, the system is ON (STBY LED not lit), when at least one of the switches is positioned ON. -
Page 9: Remote Controller, K-Remco
Command Boards / Bars, Remote Controller 2.2 Remote Controller, K-REMCO The Remote Controller consists of 12 direct function keys and the ComWheel. K-REMCO PCBs The K-REMCO has two PCBs located inside the Remote Controller. One board has only the pushbutton switches of the keys. The other board reads the status of the keys and the ComWheel and forwards the information to the CPU board. -
Page 10: Service Procedures
Field service is limited to replacing faulty PC boards or mechanical parts. The PC boards are then returned to Datex-Ohmeda for repair. Datex-Ohmeda Technical Services is always available for service advice. Please provide the unit serial number, full type designation and a detailed description of the fault. - Page 11 Command Boards / Bars, Remote Controller Check that the plastic front cover and the front panel sticker are intact. Check that the ComWheel cover is intact and is attached properly. Check that the ON/STBY -switch and its protector (in K-ANE/K-ICU) are intact and are attached properly.
-
Page 12: Remote Controller, K-Remco
S/5 Keyboards 11. Check that the Command Board/Bar functions normally after the performed electrical safety check. 12. Clean the the Command Board/Bar. Fill in all necessary documents. • 3.2.3 Remote Controller, K-REMCO Turn the monitor to STBY. • Disconnect the remote controller cable from the display controller board. •... - Page 13 Command Boards / Bars, Remote Controller Wait until normal monitoring screen appears, then check that the picture on the screen is displayed with correct resolution. If the resolution is not correct, replace the remote controller cable. Enter the service menu: Menu - Monitor Setup (on the remote controller keypad)
-
Page 14: Disassembly And Reassembly
S/5 Keyboards 3.3 Disassembly and reassembly 3.3.1 Command Board, K-ANE/ K-ICU The Command Board is disassembled according to the following procedure. Please refer to the exploded view of the Command Board. Disconnect the display power cable, the display data cable and the Command Board cable from the Central Unit. -
Page 15: Remote Controller K-Remco
Command Boards / Bars, Remote Controller 3.3.3 Remote Controller K-REMCO The Remote Controller is disassembled according to the following procedure. Please refer to the exploded view of the Remote Controller (chapter 6, spare parts). Disconnect the K-REMCO cable from the Central unit. Pull out the knob of the ComWheel. -
Page 16: Troubleshooting
S/5 Keyboards TROUBLESHOOTING 4.1 K-ANE/ K-ICU/ K-ANEB/ K-ICUB/ K-REMCO See Keyboard Service Menu in chapter 5, and perform tests available. If any of the tests fail, see explanation below. Problem Cause Treatment Keyboard cable loose or broken. D-26 ON/STBY switch not working Check the items. -
Page 17: Service Menu
Command Boards / Bars, Remote Controller SERVICE MENU Monitor Setup 1. Press the key. 2. Select Install/Service (password 16-4-34). 3. Select Service (password 26-23-8) - Keyboard. Document No. 8001589 -1... -
Page 18: Keyboard Menu
S/5 Keyboards 5.1 Keyboard menu The service menu for testing the command board functions. Upper Led is for testing the upper alarm LED (red) on the command board. When the text is highlighted, the upper alarm LED can be turned on and off by pressing the ComWheel. -
Page 19: Keyboard Type
Command Boards / Bars, Remote Controller 5.1.2 Keyboard Type Store Mask A selection for setting the anaesthesia keyboard’s language. The selected language determines the outcome of the lower keypad. Store Type is for setting the keyboard’s type; COM = Command Board ARK = Anaesthesia Keyboard AIC = Information Center Keyboard NOTE: The settings should be checked if the... -
Page 20: Spare Parts
S/5 Keyboards SPARE PARTS NOTE: Only changed part numbers are listed under later revisions. To find the desired part: check first the list of the revision that corresponds your device. If the part is not listed there, check the previous revision, etc. until you find the right number. * this part is recommended for stock Item numbers refer to the exploded view. -
Page 21: Command Board, K-Ane, K-Icu Rev. 01
Command Boards / Bars, Remote Controller 6.1.2 Command Board, K-ANE, K-ICU Rev. 01 Item Item description Order No. Command board cable, K-ANE/ICU/BLANK *893945 Command board PC board, K-ANE/ICU, D-LCC10 *893943 Plastic front cover, K-ANE/ICU/BLANK (Rev. 01) 892812 Plastic rear cover, K-ANE/ICU /BLANK (Rev. 01) 892811 6.2 Command Bar, K-ANEB, K-ICUB Rev.00 6.2.1 Command Board, K-ANEB, K-ICUB Rev. -
Page 22: Blank Command Board, K-Blank
S/5 Keyboards 6.3 Blank Command Board, K-BLANK 6.3.1 Blank Command Board, K-BLANK Rev. 00 Item Item description Order No. Command board cable, K-VHC14 (Rev.02) *(883229) Use 893945 Command board PC board, K-VCH14, K-VNC15 (883228) Use 893943 Plastic front cover, K-VHC14 (Rev. 02), K-VNC15 883178 ON/STBY switch protector 881431... -
Page 23: Remote Controller, K-Remco
Command Boards / Bars, Remote Controller 6.4 Remote Controller, K-REMCO 6.4.1 Remote Controller, K-REMCO Rev. 00 Item Item description Order No. CPU board, K-REMCO *890368 Keyboard PCB, K-REMCO 890371 Connecting plate 891427 Rotary wheel 891036 ComWheel cover 891423 Plastic rear cover, K-REMCO 891421 Plastic front cover, K-REMCO 891422... -
Page 24: Remote Controller, K-Remco Rev. 01
S/5 Keyboards 6.4.2 Remote Controller, K-REMCO Rev. 01 Item Item description Order No. ComWheel cover 898940 Plastic rear cover, K-REMCO 898939 Plastic front cover, K-REMCO 898938 6.4.3 Front panel stickers for K-ANE/ICU/REMCO K-ANE K-ANE K-ANE * K-ICU K-ICU K-ICU * Adaptation (Rev. - Page 25 Command Boards / Bars, Remote Controller 6.4.4 Front panel stickers for K-ANEB/ICUB K-ANEB K-ICUB Adaptation (Rev. 00) (Rev. 00) Order No. Order No. ..00..DA 898093 898105 ..00..DE 898084 898096 ..00..EN 898083 898095 ..00..ES 898087 898099 ..00..FI 898090 898102 ..00..FR 898085 898097 ..00..IT 898088...
- Page 26 S/5 Keyboards EARLIER REVISIONS For more service information on the earlier revisions, please refer to: Command Board revision 01 Service Manual p/n 880850 Command Board revision 02 Service Manual p/n 885930 This manual supports all later revisions. Document No. 8001589-1...
- Page 27 Appendices A, B, Service check forms, K-ANE/ICU, K-ANEB/ICUB, K-REMCO APPENDICES A, B Document No. 8001589 -1...
- Page 28 S/5 Keyboards Document No. 8001589-1...
- Page 29 Appendices A, B, Service check forms, K-ANE/ICU, K-ANEB/ICUB, K-REMCO Service check form Command Board, K-ANE/K-ICU, Command Bar, K-ANEB/K-ICUB Customer Service Keyboard type Service engineer Date OK = Test OK N.A. = Test not applicable Fail = Test Failed N.A. Fail N.A.
- Page 30 S/5 Keyboards Document No. 8001589-1...
- Page 31 Appendices A, B, Service check forms, K-ANE/ICU, K-ANEB/ICUB, K-REMCO Service check form Remote Controller, K-REMCO Customer Service Keyboard type Service engineer Date OK = Test OK N.A. = Test not applicable Fail = Test Failed N.A. Fail N.A. Fail 1. Internal parts 2.
- Page 32 S/5 Keyboards Document No. 8001589...
Need help?
Do you have a question about the AS/3 K-ANE and is the answer not in the manual?
Questions and answers