Table of Contents
Advertisement
SF-S55N
2) Operation of reference wall
The reference wall is provided in the push bar. The
opening angle of reference wall is changed according
to paper size and modes to change the front side stop
position of paper. The reference wall is operative only
when the push bar is in the following position.
Center position (while the push bar center position
sensor (PI15) is on)
The opening angle of reference wall is set based on
the paper size data which is sent from the copying
machine. The rear and front stapling positions in case
of double stapling are approximately symmetric owing
to change of opening angle of reference wall.
Bin
9−25
Center of
unloaded paper
Reference wall
Advertisement
Table of Contents
