Table of Contents
Advertisement
Caution
When installing the stapler unit, make sure that the arm
and the pin have been connected correctly.
6. Stapler rocking unit
A. Removing the stapler unit rocking motor (M4)
1)
Remove the stapler shift unit.
2)
Remove the screws (1) (2 pcs.) to remove the motor
cover (2)
3)
Remove the connector (3) and screws (4) (2 pcs.) to
remove the sensor stand (5).
4)
Remove the connector (6) and screws (7) (2 pcs.) to
remove the stapler unit rocking motor (8).
4−11
SF-S55N
Advertisement
Table of Contents
