3)
Set the hole position of two lead cams as shown
below.
4)
Holding the state of Step 3) above, put the belt (4)
on the gear, return the flange (1) to its original
position, and fix it with the E-ring (2).
J. Adjusting the tensioner
1)
Loosen the tensioner fixing screw (1), and then
tighten the tensioner fixing screw (1) in the position
where the tensioner 2 (2) is stopped by the tension
of spring (3).
K. Adjusting the tension of stapler unit shift drive belt
1)
Loosen the tensioner fixing screw (1), and then
tighten the tensioner fixing screw (1) in the place
where the tensioner (2) is stopped by the tension of
spring (3).
L. Adjusting the stapler unit home position
1)
Loosen the two screws (1), and move ahead the
flag plate to adjust the home position of stapler unit.
(Before removing the flag plate mark the fixing
position.)
2)
Make an adjustment so that the staple is located as
shown below when corner stapling is performed.
5−6
SF-S55N