Removing The P_Thick Sensor - Epson Stylus Pro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF/10600

4.3.3.28 Removing the P_THICK Sensor

1. Remove the H Top Cover as described in 4.3.1.3 "H Top Cover Removal".
2. Push the Paper Hold Lever to the front. (Unlock condition)
Figure 4-168.
3. Marking the P_THICK sensor bracket position on the CR Guide Rail.
P_THICK sensor
CR guide rail
Figure 4-169.
Disassembly & Assembly
Thank You For Using TheServiceManualShop.com
Paper hold lever
Marking
Thank You For Using TheServiceManualShop.com
4. Remove two screws (M3x6) securing the P_THICK Sensor.
P_THICK sensor
5. Disconnect the cable connector from the P_THICK Sensor.
Disassembly
Revision D
Screws
Figure 4-170.
Cable connector
Figure 4-171.
184