Others - Epson Stylus Pro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF/10600

2.2.7 Others

COVER SENSOR
The cover sensor switch is attached in cover open and close department, to detect the
open and close condition of the front cover and I/C holder cover where it is attached on
the front side of this machine.
This sensor is doing the operation/halt control of the CR motor and PF motor drive
circuit through the C362DRV board logic circuit after cover condition detection with
the sensor. This control is similar even when the paper hold lever is in cancellation
condition.
Front cover detect SW-L
Figure 2-15. Cover sensor / Panel unit
Operating Principles
Thank You For Using TheServiceManualShop.com
Front cover detect SW-R
IC holder cover SW
Thank You For Using TheServiceManualShop.com
Printer Mechanism Components
CIRCUIT BOARD PLACEMENT
There are the panel unit on surface right of this printer, and Power supply circuit board
and C362MAIN board, HJFK board, C362DRV board, circuit board in back
compartment of this printer.
C362MAIN board
C362DRV board
HJFK board
Figure 2-16. Circuit board placement
Revision D
Power board
75