Epson Stylus Pro 10000 Service Manual page 153

EPSON Stylus Pro 10000/10000CF/10600
9. Remove each two screws securing the Roller Unit (5 pieces), and remove the
Roller Unit from the Guide Unit.
Figure 4-68.
10. Remove ten screws (3x8), then push up the five Sub Platens and remove it. (Hooks
are in 2 places on the lower side.)
Sub Platen
With 1 place removed
Figure 4-69.
Disassembly & Assembly
Thank You For Using TheServiceManualShop.com
Screw
Screws
Thank You For Using TheServiceManualShop.com
Disassembly
Carry out the justify with the L style gauge, when assemble the sub
A D J U S T M E N T
R E Q U I R E D
platen. (Refer to Chapter 5 "Adjustment")
11. Disconnect the cable connector connected to C362DRV Board CN42 and maintain
the slack at the left side surface as shown below.
Cable
(slack)
Figure 4-70.
Revision D
146