Epson Stylus Pro 10000 Service Manual page 166

EPSON Stylus Pro 10000/10000CF/10600
8. Check the following points.
Weight side line and CR Frame line are
aligned in a straight line.
Bottom of Weight arrives at CR Frame.
Figure 4-103. Weight Installation Checkpoints 1
Disassembly & Assembly
Thank You For Using TheServiceManualShop.com
Weight and Weight Retainers are aligned in
a straight line.
Thank You For Using TheServiceManualShop.com
Disassembly
9. Tighten 3 screws that were temporarily set. (Torque: 10kgf) (Screws to tighten are
those shown in Figure 4-96.)
10. Remove thickness gauges.
11. Move the Head Tilt Adjuster fully to the left and right, checking that Head and
Weight have no interference. If there is interference, repeat the reassembly steps.
Figure 4-104. Weight Installation Checkpoints 2
12. Shift the Carriage to the right end, then tighten 1 screw that was temporarily set.
(Torque: 10kgf) (Screw to tighten is shown in Figure 4-94.)
13. Execute adjustments to be performed after Head replacement. (Refer to 4.3.3.3
"Replacing the Printhead".)
14. Install R Inside Cover.
15. Install L Side Cover.
16. Install R Side Cover.
17. Install Carriage Cover.
Revision D
No interference at these locations
159