Epson Stylus Pro 10000 Service Manual page 277

EPSON Stylus Pro 10000/10000CF/10600
Table 6-3. Status sheet
Item Panel display
Ink remainder quantity (K) INK LEFT(K)
Ink remainder quantity (C) INK LEFT(C)
Ink remainder quantity (M) INK LEFT(M)
Ink remainder quantity (LC) INK LEFT(LC)
Ink remainder quantity (LM) INK LEFT(LM)
Ink remainder quantity (Y) INK LEFT(Y)
Cutter life CUTTER LIFE
Total printing number of sheets TOTAL COUNT
Waste ink counting WASTE INK
CR motor life monitor CR MOTOR
PF motor life monitor PF MOTOR
Head unit life monitor HEAD UNIT
CLEANING
Cleaning unit life monitor
UNIT
Maintenance
Thank You For Using TheServiceManualShop.com
Setting value Contents
The remainder quantity of the ink
is displayed every the ink.
C : Cyan
E*****F
M : Magenta
(*1)
LC : Light cyan
LM : Light magenta
Y : Yellow
K: Black
The life of the cutter is displayed.
Cutter life be about 2000 sheets.
(However in the case of film
E*****F
system form, about 1000 sheets.)
(*1)
The life information of the cutter
is reference. Actually, judge from
the piece condition.
nnnnnnn (Max 6 The number of sheets that printed
columns) it is displayed.
This item is the maintenance
information that the service
engineer uses the maintenance for
E*****F the purpose.
(*1)
[MAINTENANCE REQ. 100]
with the remainder quantity of 3%
[SERVICE REQ. 000100] with
the remainder quantity of 0%
Thank You For Using TheServiceManualShop.com
General Maintenance Issues
*1 : The meaning of the command of the ink remainder quantity and cutter life are as
follows. Refer to 4.2.1.2.
Display Remainder quantity of the ink
E*****F Ink full condition (Full)
E**** F
E*** F
E** F
E* F
E F
Ink remainder quantity is little (The
ink end lamp blinking)
NN%
Ink low condition (10% or less of
the remainder quantity)
Ink end (The ink out indicator
0%
comes on)
Do not carry out the counter initialization without necessary part
C A U T I O N
exchange/inspection, although the counter initialize is possible with
"the counter initialization menu" of "maintenance mode 2".
(Especially, do not clear the counter of "Waste ink", "Ink
remainder quantity" to the unpreparedness, to exert the influence
on the product actuation.)
Revision D
Table 6-4.
Life of the cutter
There is a remainder life (Full)
Remainder life is little.
End
* The life of the cutter is rough
standard. When the cutter is
exchanged, display becomes full
condition.
270