Epson Stylus Pro 10000 Service Manual page 151

EPSON Stylus Pro 10000/10000CF/10600
5. While lifting the hooks on each side of the Waste Ink Box, pull it forward slowly,
and then remove the box after releasing the tabs hooked on the base frame.
Figure 4-64. Waste Ink Box
6. Remove three screws on the Ink Tube Clamp and remove it.
Ink tube clamp
Screws
Figure 4-65. Disassembly of the Waste Ink Box
Disassembly & Assembly
Thank You For Using TheServiceManualShop.com
Waste Ink Pads
Thank You For Using TheServiceManualShop.com
Disassembly
7. Remove the old waste ink absorption material, place it in a plastic bag and dispose
of it according to local regulations.
8. Insert new Waste Ink Pads (Max. 51 sheet), and re-install the Waste Ink Box to the
printer.
When replacing the Waste Ink Unit, the following adjustment
A D J U S T M E N T
R E Q U I R E D
procedures are required. (See "Maintenance Mode 2")
INIT. WASTE INK
INIT. CLEANING
To reassemble the waste ink box and related parts, follow the
C A U T I O N
above steps in reverse order and make sure you keep the following
in mind:
Insert the waste ink tubes into the ink tube clamps in a way
that they will not slip out due to vibration.
Be careful about the installation position of the waste ink
tubes. If set in an incorrect position, ink from the printer will
leak. After installing the tubes, be sure to visually check for
correct installation.
Connect to the Creaning unit.
Front side view
Connect to the flushing box.
Revision D
Figure 4-66.
144