Indicator Status In Normal Mode - Epson Stylus Pro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF/10600

1.4.1 Indicator Status in Normal Mode

Table 1-22. Operate Indicator
Printer Status
With power on and in any status other than
those listed below.
While processing data and during power off
sequence
Fatal error
Reset, timer IC reset/NVRAM clear
Table 1-23. Paper Out Indicator
Printer Status
Out of paper, end of roll
Roll paper and sheet sizes are different
Paper set lever in release position
Paper is too thick to perform cleaning
Paper jam
Paper cutting error
Paper not straight
Paper check error
Problem with paper output (sheet)
Fatal error
Reset, timer IC reset/NVRAM clear
Maintenance call
Product Description
Thank You For Using TheServiceManualShop.com
Indicator
On
Blink
Blink
On
Indicator
On
On
On
On
Blink
Blink
Blink
Blink
Blink
Blink
On
On for 100ms at intervals
of 5 seconds
Thank You For Using TheServiceManualShop.com
Operating Panel
Table 1-24. Pause Indicator
Printer Status
Print ready
In SelecType mode
During pause
During ink drying time
During ink sequence
Other errors
Fatal error
Reset, timer IC reset/NVRAM clear
Table 1-25. Ink Out Indicators
Printer Status
Out of specified ink
No cartridge for specified ink
Wrong cartridge for specified ink
Illegal cartridge for specified ink
Ink level low
Fatal error
Reset, timer IC reset/NVRAM clear
Table 1-26. Paper Source Indicator
Printer Status
Selected paper source
Fatal error
Difference with roll paper and sheet
Reset, timer IC reset/NVRAM clear
Revision D
Indicator
Off
Off
Off
Blink
Blink
Off
Blink
On
Indicator
On
Blink
Blink
On
Indicator
On
Blink
Blink
On
32