How To Wire Connectors - Mitsubishi Electric MELSERVO MR-MT2010 Instruction Manual

3. INSTALLATION

3.5 How to wire connectors

(1) Connecting and disconnecting cables
Use the accessory connectors for wiring.
Model
MR-MT2010
MR-MT2100
MR-MT2200
MR-MT2300
MR-MT2400
(a) Fabrication on cable insulator
Use wires with the size of AWG 24 to 16 and strip the wires to make the stripped length 10 mm ± 0.5
mm at the ends of the wires.
(b) Inserting wires
While pressing the release button with a flat head screwdriver with the blade edge width of 2.0 mm
to 2.5 mm, insert a wire all the way in. Then, remove the screwdriver.
We recommend that you use the flat head screwdriver "model: SZS 0,4X2,5, product No.: 1205037"
manufactured by Phoenix Contact.
(c) Disconnecting wires
While pressing the release button with the flat head screwdriver, pull out the wire.
CN2
CN1
CN2
CN1
CN2
CN1
CN2
CNP1
CN1
CN2
Release button
Wire insertion hole
3 - 10
Accessory connector
DFMC-1,5/12-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/9-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/10-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/12-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/12-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/8-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/8-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/4-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/11-STF-3,5 or equivalent (Phoenix Contact)
DFMC-1,5/11-STF-3,5 or equivalent (Phoenix Contact)
Upper
row
Lower
row
Flat head Wire
screwdriver
Remove the screwdriver
to connect the wire.