Mitsubishi Electric MELSERVO MR-MT2010 Instruction Manual page 3

1. To prevent electric shock, note the following
Ground the sensing module securely.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the sensing module until it has been installed. Otherwise, it may cause an electric
shock.
Do not operate switches with wet hands. Otherwise, it may cause an electric shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, it may cause an electric
shock.
To avoid an electric shock, insulate the connections of the power supply terminals.
2. To prevent fire, note the following
Install the sensing module on incombustible material. Installing them directly or close to combustibles will
lead to smoke or a fire.
Always connect a circuit protector between the power supply and the power supply (24 V(+)) of the
sensing module, in order to configure a circuit that shuts down the power supply on the side of the
sensing module power supply. If a circuit protector is not connected, a continuous flow of a large current
may cause smoke or a fire when the sensing module malfunctions.
Provide an adequate protection to prevent screws and other conductive matter, oil and other combustible
matter from entering the sensing module.
3. To prevent injury, note the following
Only the voltage specified in the Instruction Manual should be applied to each terminal. Otherwise, a
burst, damage, etc. may occur.
Connect cables to the correct terminals. Otherwise, a burst, damage, etc. may occur.
Ensure that polarity (+/-) is correct. Otherwise, a burst, damage, etc. may occur.
4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a malfunction, injury,
electric shock, fire, etc.
(1) Transportation and installation
Transport the products correctly according to their mass.
Stacking in excess of the specified number of product packages is not allowed.
Install the sensing module in a load-bearing place in accordance with the Instruction Manual.
Do not get on or put heavy load on the equipment.
The equipment must be installed in the specified direction.
WARNING
CAUTION
CAUTION
CAUTION
A - 2