Chapter 3 Connectors Used For Direct Drive Motor Wiring; Selection Of Connectors - Mitsubishi Electric MELSERVO-J5 TM-RG2M Series User Manual

3
CONNECTORS USED FOR DIRECT DRIVE
MOTOR WIRING
Precautions
• The IP rating indicated is the connector's protection against ingress of dust and water when the connector is connected to a
servo amplifier, direct drive motor, or absolute position storage unit.
• If the IP rating of the connector, servo amplifier, direct drive motor, and absolute position storage unit varies, the overall IP
rating depends on the lowest IP rating of all components.
3.1

Selection of connectors

Use the connector configuration products given in the table as the connectors for connection with the direct drive motor. Refer
to the following for the compatible connector configuration products.
Page 14 Wiring connectors (connector configurations A/B/C/D/E)
Power connector Encoder connector
Direct drive motor
TM-RFM_C20
TM-RFM_E20
TM-RFM_G20
TM-RFM040J10
TM-RFM120J10
TM-RG2M002C30
TM-RU2M002C30
TM-RG2M004E30
TM-RU2M004E30
TM-RG2M009G30
TM-RU2M009G30
*1 Used in the absolute position detection system
Servo amplifier-side
connector
Absolute position storage unit
MR-BTAS01
Wiring connector
For power supply For encoder
Connector configuration B Connector configuration A
Connector configuration C
Connector configuration D
Connector configuration B
3 CONNECTORS USED FOR DIRECT DRIVE MOTOR WIRING
Encoder-side
connector
Absolute position storage unit (option)
Servo amplifier side
Connector configuration A
*1
Encoder side
Connector configuration E
3.1 Selection of connectors
3
13