Parts Identification - Mitsubishi Electric MELSERVO MR-MT2010 Instruction Manual

4. MR-MT2010 SSCNET III/H HEAD MODULE

4.4 Parts identification

(3)
(4)
No.
Status display LED (RUN)
(1)
Indicates the operating state of the module.
Status display LED (ERR)
(2)
Indicates that an error has occurred in the module.
Station number selection rotary switch (SW1)
(3)
Use this switch and SW2 to set a start station number of the sensing module.
Station number selection rotary switch (SW2)
(4)
Use this switch and SW1 to set a start station number of the sensing module.
SSCNET III cable connector (CN1A)
(5)
Connect the servo system controller, previous axis servo amplifier, or head module.
SSCNET III cable connector (CN1B)
(6)
Connect the next axis servo amplifier or head module. Put a cap on this connector for the final module.
Power supply and I/O signal connector (CN2)
(7)
Connect the input power supply and digital I/O signals.
Inter-module connection connector (CN3)
(8)
Connect extension modules to be used.
(1)
(2)
(5)
(6)
(7)
Name/application
4 - 2
(8)
Detailed
explanation
Section
4.6
Section
4.5
Section
3.4
Section
4.7