Mitsubishi Electric MELSERVO MR-MT2010 Instruction Manual page 82

7. MR-MT2300 ANALOG I/O MODULE
(2) Analog output
MR-MT2300
(Note 4)
AG
Note 1. Use a two-core twisted cable for wiring.
2. When there is a potential difference between the AG terminal and the GND of an external device, connect the AG
terminal and the GND of the external device.
3. Be sure to connect the shielded wire of each channel to the SHD terminal and ground the FG terminal.
4. The AG terminal and the AOUT_N terminal of each channel are connected inside the module.
5. The load resistance of external device must be 1 kΩ or higher.
CN2
AOUT_P
AOUT_N
Shield
(Note 3)
AG (Note 2)
SHD
CNP1
FG
10 m or less
(Note 1)
(Note 2)
7 - 7
External device
(Note 5)
GND