Stand Mode Sensitivity; Stand Mode Illumination Off Time - Datalogic PowerScan 9500 Series Product Reference Manual

Stand Mode Sensitivity

Sets the sensitivity level for stand mode wakeup. Choices are low, medium
and high.
$CSMSE01(CR)
Stand Mode Sensitivity = Medium

Stand Mode Illumination Off Time

Specifies the amount of time reader illumination stays off after pulling the
trigger when in Stand Mode. The configurable range is 01 to 32 by 01 in
increments of 500ms (500ms to 16 seconds). See
for a description of this feature.
$CSNTM
Select Stand Mode Time Setting
Product Reference Guide
04 = 2 Seconds
DEFAULT
Enter/Exit Programming Mode
$CSMSE00(CR)
Stand Mode Sensitivity = Low
DEFAULT
$CSMSE02(CR)
Stand Mode Sensitivity = High
page 296
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
in "References"
repre-
73