Wedge Quiet Interval; Intercharacter Delay - Datalogic QuickScan 2500 Series Product Reference Manual

OTHER KEYBOARD PARAMETERS

Wedge Quiet Interval

This option specifies the amount of time to look for keyboard activity before the reader
breaks the keyboard connection in order to transmit data to host. The selectable range
for this feature is from 0 to 990ms in 10ms increments. See "
page 269
Select Wegde Quiet Interval Setting
$CKBQI
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-
onds in 10ms increments. A setting of zero specifies no delay. See "
on page 270
$CR2IC00
Select Intercharacter Delay Setting
$CR2IC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
for more detailed programming instructions.
NOTE: This feature applies ONLY to the Keyboard Wedge interface.

10 = Quiet Interval of 100 msec
for more detailed programming instructions.

00 = No Intercharacter Delay
ENTER/EXIT PROGRAMMING MODE
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
CANCEL
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
CANCEL
Wedge Quiet Interval" on
Appendix D,
Intercharacter Delay"
Appendix D,
PRODUCT REFERENCE GUIDE
69