Usb Interface; Gpib Interface (Only For It6500(G) Series) - ITech IT6500C Series User Manual

•
Native machine address: (0 ~31, factory default is 0)
Start Bit

4.2 USB Interface

Use a cable with two USB ports to connect power supply and PC. You can
program through USB interface to achieve all functions of power supply.
The functions of USB488 interface are as follows:
•
•
•
The functions of power supply's USB488 are as follows:
•
•
•
•

4.3 GPIB Interface (Only for IT6500(G) Series)

Use a IEEE488 bus to connect GPIB interfaces of power supply and PC. Please
ensure that the screws have been screwed down in order to have a full
connection. Then press [Shift] +[P-set] (Menu) to enter the system menu to set
the address. The address range of power supply is 1-30. After you set the
address, please press [Enter] button to confirm. GPIB address is saved in
nonvolatile memory.
NONE 8 data bits have no parity
8 Data Bits
Interface is 488.2 USB488 interface
Receive the following request: REN_CONTROL, GO_TO_LOCAL, and
LOCAL_LOCKOUT
When the interface receives MsgID = TRIGGER USBTMC command, it will
transmit the TRIGGER command to the function layer
receive all SCPI commands
device is SR1 enabled
device is RL1 enabled
device is DT1 enabled
Copyright © Itech Electronic Co., Ltd.
Parity=None Stop Bit
Remote Control
85