Using The Web Interface - ITech IT6500C Series User Manual

6. After setting, press [Esc] to exit.

4.4.1 Using the Web Interface

The instrument has a built-in Web interface for monitoring and controlling the in-
strument via a Web browser. To use the Web interface, connect the instrument
and PC over LAN and enter the instrument's IP address into the address bar at
the top of your PC's Web browser, you can access the front panel control func-
tions including the LAN configuration parameters.
•
•
•
As shipped, the login password of the Web interface defaults to 12345678. To
change the password, click the Security button in the navigation bar on the left
side of the window after login.
Enter the password and then click the LOGIN button, the Web Interface will ap-
pear in the browser as shown below. The following figure is just as an example
and the Web interface of different models are different. The actual shown page
shall be subject to the connected instrument.
Please confirm the IP address and Gateway is configured correctly. The detailed
information refer to the Configure LAN Interface Information.
You must enable Web service if you wish to remotely control your instrument us-
ing its built-in Web interface. Refer to LAN services setting for the detailed oper-
ation procedures.
Up to six simultaneous connections are allowed. With additional connections,
performance will be reduced.
Copyright © Itech Electronic Co., Ltd.
Remote Control
89