ITech IT6500C Series User Manual page 98

•
Gateway: This value is the IP Address of the default gateway that allows the
instrument to communicate with systems that are not on the local subnet, as
determined by the subnet mask setting. The same numbering notation
applies as for the IP Address. A value of 0.0.0.0 indicates that no default
gateway is defined.
•
DNS1: This field enters the primary address of the server. Contact your LAN
administrator for server details. The same numbering notation applies as for
the IP Address. A value of 0.0.0.0 indicates that no default server is defined.
DNS is an internet service that translates domain names into IP addresses.
It is also needed for the instrument to find and display its hostname assigned
by the network. Normally, DHCP discovers the DNS address information;
you only need to change this if DHCP is unused or not functional.
•
DNS2: This field enters the secondary address of the server. Contact your
LAN administrator for server details. The same numbering notation applies
as for the IP Address. A value of 0.0.0.0 indicates that no default server is
defined.
LAN service
The configurable services include: mDNS, Ping, Telnet, Web, VXI-11 and Raw
Socket.
The operation steps to configure are as follows.
•
This configures the instrument address (IP Mode).
1. Press [Shift]+[P-set](Menu) to enter into the system menu interface.
2. se left and right keys or rotate the voltage knob to select SYSTEM and
press [Enter]key enter to system menu.
3. se left and right keys or rotate the voltage knob to select
Communication and press [Enter]key to confirm.
4. se left and right keys or rotate the voltage knob to select LAN and press
[Enter]key to confirm.
Select Config to configure.
5. Press [Enter]key to confirm, This parameter is in modification.
– Auto: automatically configure the addressing of the instrument
– Manual: manually configure the addressing of the instrument
6. After setting, press [Esc] to exit.
•
This selects the LAN services to enable or disable (Server Config).
1. Press [Shift]+[P-set](Menu) to enter into the system menu interface.
2. se left and right keys or rotate the voltage knob to select SYSTEM and
press [Enter]key enter to system menu.
3. se left and right keys or rotate the voltage knob to select
Communication and press [Enter]key to confirm.
4. se left and right keys or rotate the voltage knob to select LAN and press
[Enter]key to confirm.
5. se left and right keys or rotate the voltage knob to select Server-Config
and press [Enter]key to confirm.
Copyright © Itech Electronic Co., Ltd.
Remote Control
87