ITech IT6500C Series User Manual page 37

Config menu
CONFIG
Load-Status
Monitor
Ext- Ctrl
Parallel
Loop-Mode
Last
Setting the load status.
Load
Off（Def）
On
Static-Curr Setting the static current when output is Off
Off
On（Def）
10V(Def)
5V
External control mode and related parameter
setting
Voltage（Def）
10V(Def)/5V
Resistance
10k/5k
Off
On
Parallel mode set up
Single
Master
Slave
Control loop setting
CV-Loop
Copyright © Itech Electronic Co., Ltd.
Function and Features
If output was on prior to
turning the power off, the ON
state will be resumed after
power on.
disable internal load function.
enable internal load function.
Turn off static current function
(avoid current flow-backward)
Turn on static current
function (clear voltage
mantissa)
10V monitoring mode options
5V monitoring mode options
Voltage setting mode selection
10V or 5V setting mode selection.
select by left/right key.
Resistance setting mode
selection.
10K or 5K setting mode
selection, select by left/right
key.
Disable or enable this function.
Select by up/down key.
Single mode
Act as a master mode
Master Mount: Master Mount: total
number of instruments in parallel.
Act as a slave mode
CV loop control
High(Def): High speed
Low: Low speed
26