Rear Panel Connectors And Ports - Oracle Sun SPARC T3-2 Installation Manual

Rear Panel Connectors and Ports

No. Cable Port or Expansion Slot
1 Power supply 0 AC inlet
2 Power supply 1 AC inlet
3 SPARC T3-2 Server 10 Gb Network Module
QSFD port
4 Network 10/100/1000 ports (NET0, NET1,
NET2, and NET3)
5 USB ports (USB 0, USB 1)
Description
Use the supplied or supported AC power cords.
Note - Do not attach power cords to the power supplies until
you have finished connecting the data cables and have
connected the server to a serial terminal or a terminal
emulator (PC or workstation).
The SPARC T3-2 Server 10 Gb Network Module card's QSFD
port provides four 10 Gb connections when using a supported
transceiver and cable.
The four Gigabit Ethernet ports enable you to connect the
system to the network.
Note - Using the ILOM sideband management feature, you
can access the SP using one of these ports. Refer to the SPARC
T3 Series Servers Administration Guide for instructions.
The two USB ports support hot-plugging. You can connect
and disconnect USB cables and peripheral devices while the
server is running, without affecting system operations.
Note - You can connect up to 126 devices to each of the four
USB controllers (two ports in front, two ports in back), for a
total of 504 USB devices per server.
Connecting the Server Cables 37