Assign A Static Ip Address To The Sp - Oracle Sun SPARC T3-2 Installation Manual

▼ Assign a Static IP Address to the SP

If your network uses DHCP to assign IP addresses, the DHCP device will
automatically assign an IP address to the service processor. If your network does not
use DHCP, follow this procedure to assign a static IP address to the service processor.
Note – For more information on configuring ILOM, refer to the SPARC T3 Series
Servers Administration Guide and the ILOM documentation.
1. Log in to the service processor using a serial connection through the SER MGT
port.
For serial connection instructions, see
MGT Port" on page
default root password) to display the ILOM (->) prompt.
hostname login: root
Password: password (nothing displayed)
Oracle(R) Integrated Lights Out Manager
Version 3.0.12.2
Copyright (c) 2010, Oracle and/or its affiliates. All rights reserved.
Warning: password is set to factory default.
->
2. Set the service processor to accept a static IP address.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
3. Set the IP address for the service processor.
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
4. Set the IP address for the service processor gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
"Connect a Terminal or Emulator to the SER
51. Log in to the service processor as root (changeme is the
Powering On the Server for the First Time 57