Table of Contents
Advertisement
4. (Optional) If you chose to secure the slide rail assembly to the rack with screws,
insert the M6 mounting screws through both front and rear slide rail brackets
and rack posts, and then secure the screws to the rack posts with the caged nuts.
5. Repeat
Step 2
through
Caution – If your rack does not have an anti-tip device, the rack could tip over
when installing the server.
6. If available, extend the anti-tip legs or anti-tip bar at the bottom of the rack.
Refer to your rack documentation for instructions. For more information, see
"Stabilize the Rack for Installation" on page
Related Information
"Disassemble Slide Rails" on page 20
■
"Install Mounting Brackets" on page 22
■
"Install Server Into the Slide Rail Assemblies" on page 26
■
Step 4
for the remaining slide rail assembly.
20.
Installing the Server
25
Advertisement
Table of Contents
