Connect A Terminal Or Emulator To The Ser Mgt Port - Oracle Sun SPARC T3-2 Installation Manual

After the system console finishes its low-level system diagnostics, the service
processor initializes and runs a suite of higher level diagnostics. When you access the
service processor using a device connected to the serial management port, you see
the output of the ILOM diagnostics.
By default, the service processor configures the network management port
automatically, retrieving network configuration settings using DHCP and allowing
connections using SSH.
For a more detailed discussion on configuring the system console and connecting
terminals, refer to the SPARC T3 Series Servers Administration Guide.
Related Information
SPARC T3 Series Servers Administration Guide
■
ILOM documentation
■
"Power On the System for the First Time" on page 52
■
"Assign a Static IP Address to the SP" on page 57
■
▼ Connect a Terminal or Emulator to the
SER MGT Port
Prior to powering on the server for the first time, make a serial connection to the
service processor. After making this serial connection, you will be able to view the
system messages when you connect the power cords.
1. Confirm that you have completed all of the preparations for installation.
See the instructions in
2. Confirm that you have completed the installation of the server in a rack.
See the instructions in
"Preparing for the Installation" on page
"Connecting the Server Cables" on page
Powering On the Server for the First Time
1.
35.
51