Table of Contents
Advertisement
▼ Install Server Into the Slide Rail
Assemblies
Use this procedure to install the server chassis, with mounting brackets, into the slide
rail assemblies that are mounted to the rack.
Caution – This procedure requires a minimum of two people because of the weight
of the server. Attempting this procedure alone could result in equipment damage or
personal injury.
Caution – Always load equipment into a rack from the bottom up so that the rack
will not become top-heavy and tip over. Extend your rack's anti-tip bar or anti-tilt
legs to prevent the rack from tipping during equipment installation. See
the Rack for Installation" on page 20
1. Push the slide rails into the slide rail assemblies in the rack as far as possible.
2. Raise the server so that the rear ends of the mounting brackets are aligned with
the slide rail assemblies that are mounted in the rack.
26
SPARC T3-2 Server Installation Guide • March 2012
for more information.
"Stabilize
Advertisement
Table of Contents
Need help?
Do you have a question about the Sun SPARC T3-2 and is the answer not in the manual?
Questions and answers