Hardware
MSR 20
MSR 30
MSR 50
MSR 2600
MSR3600-51F
To change the aggregation mode of an aggregation group that contains member ports, remove all
the member ports from the aggregation group first.
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to operate in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation port-priority
Use link-aggregation port-priority to set the aggregation priority of a port.
Use undo link-aggregation port-priority to restore the default setting.
Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
Default
The aggregation priority of a port is 32768.
Views
Ethernet interface view
Default command level
2: System level
Parameters
port-priority: Specifies a port aggregation priority in the range of 0 to 65535. The smaller the value,
the higher the port aggregation priority.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
Command compatibility
No
Yes
Yes
Yes
Yes
Command compatibility
Yes
No
Yes
Yes
No
109