Default - H3C MSR Series Command Reference Manual

[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] bandwidth 10000

default

Use default to restore the default settings for an aggregate interface or subinterface.
Syntax
default
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view, Layer 3 aggregate subinterface
view
Default command level
2: System level
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of
the impacts of this command when you execute it on a live network.
The following matrix shows the command and hardware compatibility in Layer 2 aggregate interface
view:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
MSR 20
MSR 30
MSR 50
MSR 2600
MSR3600-51F
This command might fail to restore the default settings for some commands for reasons such as
command dependencies and system restrictions. Use the display this command in interface view to
identify these commands, and then use their undo forms or follow the command reference to
individually restore their default settings. If your restoration attempt still fails, follow the error
message instructions to resolve the problem.
Examples
# Restore the default settings for Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] default
This command will restore the default settings. Continue? [Y/N]:y
Command compatibility
Yes
No
Yes
Yes
No
No
Yes
Yes
Yes
Yes
92