Interface Bridge-Aggregation - H3C MSR Series Command Reference Manual

Default
LinkUp/linkDown trap generation is enabled for an aggregate interface.
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view, Layer 3 aggregate subinterface
view
Default command level
2: System level
Usage guidelines
The following matrix shows the command and hardware compatibility in Layer 2 aggregate interface
view:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
MSR 20
MSR 30
MSR 50
MSR 2600
MSR3600-51F
For an aggregate interface to generate linkUp/linkDown traps when its link state changes, you must
enable linkUp/linkDown trap generation globally with the snmp-agent trap enable [ standard
[ linkdown | linkup ] * ] command.
For more information about the snmp-agent trap enable command, see Network Management and
Monitoring Command Reference.
Examples
# Enable linkUp/linkDown trap generation on Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] snmp-agent trap enable
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] enable snmp trap updown

interface bridge-aggregation

Use interface bridge-aggregation to create a Layer 2 aggregate interface and enter the Layer 2
aggregate interface view.
Use undo interface bridge-aggregation to remove a Layer 2 aggregate interface.
Syntax
interface bridge-aggregation interface-number
undo interface bridge-aggregation interface-number
Command compatibility
Yes
No
Yes
Yes
No
No
Yes
Yes
Yes
Yes
105