Vlan Termination Configuration Commands; Dot1Q Ethernet-Type - H3C MSR Series Command Reference Manual

VLAN termination configuration
commands

dot1q ethernet-type

Use dot1q ethernet-type to set the TPID value in the outermost VLAN tag of packets received and
sent by the interface.
Use undo dot1q ethernet-type to restore the default.
Syntax
dot1q ethernet-type hex-value
undo dot1q ethernet-type
Default
The TPID value for the outmost VLAN tag of VLAN-tagged packets received and sent by the
interface is 0x8100.
Views
Layer 3 Ethernet interface view, Layer 3 aggregate interface view, Layer 3 VE interface view,
VE-L3VPN-Access interface view
Default command level
2: System level
Parameters
hex-value: Sets the hexadecimal tag protocol identifier (TPID) value, in the range of 0x1 to 0xFFFF
and excluding the common protocol type values listed in
Table 34 Common protocol type values
Protocol
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
802.1X
Cluster
Reserved on the device
Table 34.
Value
0x0806
0x0200
0x8035
0x0800
0x86DD
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF
154