H3C MSR Series Command Reference Manual page 24

Field
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing :
disabled
Internet Address is 192.168.1.54/24
Primary
Internet Address is 6.4.4.4/24 Sub
IP Packet Frame Type
Hardware address
IPv6 Packet Frame Type
Last clearing of counters
Last 300 seconds input: 0 bytes/sec
0 packets/sec
Last 300 seconds output: 0
bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interface(s)
under route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Description
have failed).
•
UP—Both the administrative state and the physical state of the
VLAN-interface are up.
Link layer protocol state of a VLAN-interface:
•
DOWN—The protocol state of the VLAN-interface is down.
•
UP—The protocol state of the VLAN-interface is up.
Description string of a VLAN-interface.
MTU of a VLAN-interface.
The interface is not capable of processing IP packets. This
information is displayed when the interface is not configured with an
IP address.
The primary IP address of the interface is 192.168.1.54/24. This
information is displayed only if the primary IP address is configured
for the interface.
The secondary IP address of the interface is 6.4.4.4/24. This
information is displayed only if a secondary IP address is configured
for the interface.
IPv4 outgoing frame format.
MAC address corresponding to a VLAN-interface.
IPv6 outgoing frame format.
Time when the reset counters interface vlan-interface command
was last used to clear the interface statistics.
Never indicates the reset counters interface vlan-interface
command has never been used on the interface after the device's
startup.
Average rate of input packets in the last 300 seconds (in bps and
pps).
Average rate of output packets in the last 300 seconds (in bps and
pps).
Total number and size (in bytes) of the received packets of the
interface and the number of the dropped packets.
Total number and size (in bytes) of the sent packets of the interface
and the number of the dropped packets.
Brief information about Layer 3 interfaces.
Link layer state of an interface:
•
ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
•
Stby—The interface is operating as a standby interface. To see
the main interface, use the display standby state command.
If the network layer protocol state of an interface is shown as UP, but
its link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To
16