H3C MSR Series Command Reference Manual page 32

Default command level
2: System level
Parameters
vlan-id1, vlan-id2: Specifies a VLAN ID in the range of 1 to 4094.
vlan-id1 to vlan-id2: Specifies a VLAN range. vlan-id2 must be no smaller than vlan-id1.
all: Creates or removes all VLANs except reserved VLANs. The keyword is not supported when the
maximum number of VLANs that can be created on a router is less than 4094.
The following matrix shows the all keyword and hardware compatibility:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
MSR 20
MSR 30
MSR 50
MSR 2600
MSR3600-51F
Usage guidelines
You cannot create or remove the default VLAN (VLAN 1).
You cannot create or remove VLANs reserved for specific functions.
To remove the following VLANs, remove the related configurations first, because you cannot use the
undo vlan command to directly remove them:
•
Protocol reserved VLANs
•
Voice VLANs
•
Management VLANs
•
Dynamic VLANs
Examples
# Create VLAN 2, and enter VLAN 2 view.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2]
# Create VLAN 4 through VLAN 100.
<Sysname> system-view
[Sysname] vlan 4 to 100
Please wait............. Done.
Related commands
display vlan
Keyword compatibility
No
No
No
No
No
No
Yes
Yes
Yes
Yes
24