Usage guidelines
If you specify no VLAN in the undo instance command, all VLANs mapped to the specified MSTI will
be remapped to the CIST.
You cannot map the same VLAN to different MSTIs. If you map a VLAN that has been mapped to an
MSTI to a new MSTI, the old mapping will be automatically removed.
After configuring this command, run the active region-configuration command to activate the
VLAN-to-instance mapping.
Examples
# Map VLAN 2 to MSTI 1.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
Related commands
•
display stp region-configuration
•
check region-configuration
•
active region-configuration
region-name
Use region-name to configure the MST region name.
Use undo region-name to restore the default MST region name.
Syntax
region-name name
undo region-name
Default
The MST region name of a device is its MAC address.
Views
MST region view
Default command level
2: System level
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Usage guidelines
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a device
determine the device's MST region.
After configuring this command, run the active region-configuration command to activate the
configured MST region name.
Examples
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
62