First-Time Installation - Nortel 2001 Installation And Operation Manual

First-time installation

IP address assignments
3 If an Ac power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 12 on page 89.
4 Understand the three configuration modes that you can choose from as
you proceed through the installation of the IP Phone 2004 . The three
configuration modes are:
• Static IP address
• Dynamic Partial DHCP – see "Dynamic IP address assignment —
Partial DHCP" on
• Dynamic Full DHCP
DHCP" on
5 A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
To install and configure an IP Phone 2004 , you must first install a Voice
Gateway Media Card in the system.
CAUTION
Damage to Equipment
Do not plug your IP Phone 2004 into an ISDN
connection. Severe damage can result. Consult your
system administrator to ensure that you are plugging
your telephone into a 10/100BaseT Ethernet jack.
During the first-time installation, there are IP address parameters that are
entered either manually or automatically depending on the installation
configuration. As well, you are prompted to enable or disable 802.1Q. For
more information, see "802.1Q VLAN description" on
The three configuration modes for the IP Phone 2004 are described below.
Nortel Networks IP Phone 2004
–
see "Static IP address assignment" on
page 92.
–
see "Dynamic IP address assignment — Full
page 92.
End of Procedure
IP Phones Description, Installation, and Operation
Page 91 of 302
page 92.
page 257.