Nortel 2001 Installation And Operation Manual page 58

Page 58 of 302 Nortel Networks IP Phone 2002
553-3001-368 Standard 4.00
Procedure 9
Pre-installation checklist
1 Ensure there is one IP Phone 2002 boxed package for each IP Phone
2002 being installed. The package contains:
• IP Phone 2002
• Handset
• Handset cord
• Footstand
• 2.3 m (7') Cat5 Ethernet cable
• Getting Started card
2 To install and configure an IP Phone 2002, the host system must be
installed with the Voice Gateway Media Card.
3 If an AC power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 8 on page 56.
4 Understand the three configuration modes that you can choose as you
proceed through the installation of the IP Phone 2002. The three
configuration modes are:
• Static IP address
• Dynamic Partial DHCP (see "Dynamic IP address assignment —
Partial DHCP" on
• Dynamic Full DHCP (see "Dynamic IP address assignment — Full
DHCP" on
5 A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
February 2005
(
see "Static IP address assignment" on
page 59)
page 60)
End of Procedure
page 59)