Nortel 2001 Installation And Operation Manual page 62

Page 62 of 302 Nortel Networks IP Phone 2002
553-3001-368 Standard 4.00
5 Power the IP Phone 2002 using either the Power over Ethernet or an AC
power transformer (local power).
Timing information
There are only four seconds between plugging in the IP Phone 2002
power transformer and the appearance of the Nortel Networks logo on
the display. When you see the logo, you have one second to respond by
pressing the four feature keys at the bottom of the display in sequence
from left to right. If you miss the one-second response time, the
IP Phone 2002 attempts to locate the connect server. Wait until it is
finished, and then begin the power-up sequence again.
a. If local power is used, plug the AC power transformer into the nearest
power outlet.
b. Ensure the correct AC power transformer is used. The voltage rating
of the transformer must match the wall outlet voltage. Refer to Table
8 on page 56. Connect the power jack as shown in Figure 6 on
page 61. Be sure to thread the cord around the retaining hook to
provide strain relief for a secure power connection.
6 When the Nortel Networks logo appears on the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt DHCP Yes/No?, select No.
8 Enter the following information provided by your system administrator:
Screen prompt
set IP
net msk
def gw
February 2005
IMPORTANT!
Description
A valid IP Phone 2002 IP address.
A subnet mask.
The default Media Gateway for the IP Phone
2002 on the LAN segment to which it is
connected.