Nortel 2001 Installation And Operation Manual page 278

Page 278 of 302
553-3001-368 Standard 4.00
Appendix B: IP Phone diagnostic utilities
Figure 56
Ethernet Statistics data display page
1.Link: UP/Down
2.Duplex:Full/Half
3.Speed: xxx (MB)
4.Auto Sense/Negotiate
Auto-Nego Capability:Y/N
Auto-Nego Completed:Y/N
5.VLANPriority:xxx
6.VLANID:xxxx
7.PktColl:xxxxxxxxxx
8.CRCErrors:xxxxxxxxxx
9.FrameErrors:xxxxxxxxxx
In Figure 56,
• Duplex = duplex mode
• Speed = network speed 10MB/100MB
• Auto Sense/Negotiate = Auto Negotiate Protocol Received or Not
(Y – Yes, N – No)
Note: In the IP Phone Configuration menu, Auto Negotiate mode is
the default setting for initial startup. If the telephone is connected to a
network that supports Auto Negotiate, it selects the best speed and
duplex mode available. For more information, see "Full Duplex mode"
on page 41, on page 72, and on page 103.
• VLANPriority = IP Phone VLAN priority
• VLANID = IP Phone VLAN ID
• PCollision = network packet collision peg counts
• CRCErrors = network CRC errors peg counts
• FrameErrors = network Framing errors peg counts
February 2005