Nortel 2001 Installation And Operation Manual page 98

Page 98 of 302 Nortel Networks IP Phone 2004
553-3001-368 Standard 4.00
a. Connect one end of the handset cord to the handset jack on the back
of the telephone identified with a handset icon.
b. Connect the other end of the handset cord to the handset.
4 Choose one of the following connections:
a. For a telephone not sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN ethernet
port located on the back of the telephone (identified with a LAN icon).
The other end of the CAT5 Ethernet cable plugs into the IP network.
b. For a telephone sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN ethernet
jack located on the back of the telephone (identified with a LAN icon,
see Figure 6 on
a second CAT5 Ethernet cable into the PC ethernet jack located on
the back of the telephone (identified with a PC icon, see Figure 6 on
page 61) and the other end into the computer.
Timing information
There are only four seconds between plugging in the IP Phone 2004 's
power transformer and the appearance of the Nortel Networks logo on
the display. When you see the logo, you have one second to respond by
pressing the four feature keys at the bottom of the display in sequence
from left to right. If you miss the one second response time, the IP
Phone 2004 attempts to locate the connect server. Wait until it is
finished, and then begin the power up sequence again.
5 Power the IP Phone 2004 using either the Power over Ethernet or an AC
power transformer (local power).
February 2005
page 61) and the other end to the IP network. Insert
IMPORTANT!