Before You Begin - Nortel 2001 Installation And Operation Manual

Page 28 of 302 Nortel Networks IP Phone 2001
Table 4
IP Phone 2001 components list (Part 2 of 2)
Power transformer 3 prong AC to AC, direct plug-in, 8W, 240
VAC, 50Hz to 16 VAC at 500 mA (Ireland and UK)
Power transformer AC to AC, direct plug-in, 8W, 230 VAC, 50/
60 Hz, to 16 VAC at 500 mA (Europe)
Power transformer 2 prong wall plug direct plug-in AC to AC,
8W, 240 VAC, 50 Hz, to 16 VAC at 500 mA (Australia and New
Zealand)
Power transformer AC to AC, direct plug-in, 8W, 100 VAC, 50
Hz, to 16 VAC at 500 mA

Before you begin

553-3001-368 Standard 4.00
For more information, and for information about previous versions of the IP
Phone, contact Nortel Networks.
The following section provides a step-by-step guide through the
IP Phone 2001 installation process. Before installing the IP Phone 2001,
complete the following pre-installation checklist.
Procedure 1
Pre-installation checklist
1 Ensure there is one IP Phone 2001 boxed package for each IP Phone
2001 being installed. The package contains:
• IP Phone 2001
• Handset
• Handset cord
• Footstand
• 2.3 m (7 foot) Cat5 Ethernet cable
• Getting Started card
2 To install and configure an IP Phone 2001, the host system must be
installed with the Voice Gateway Media Card.
February 2005
A0656598
A0619635
A0647042
A0828858