Nortel 2001 Installation And Operation Manual page 36

Page 36 of 302 Nortel Networks IP Phone 2001
553-3001-368 Standard 4.00
The IP Phone 2001 registers with the Terminal Proxy Server (TPS) and if
needed, begins the firmware download. This takes several minutes.
When complete, the IP Phone 2001 resets.
Note: Port 5105 on the system must be explicitly open to enable
firmware download. For more information, refer to IP Line: Description,
Installation, and Operation (553-3001-365).
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labelling keys also appear.
16 Check for dial tone and the correct DN above the display.
17 Secure the telephone footstand to the base of the telephone. Use the
angle adjustment grip on the top back of the telephone to adjust the
position.
18 (Optional) Customize the feature keys as required. For more information,
see IP Phone 2001 User Guide.
Procedure 3
Installing an IP Phone 2001 for the first time using DHCP
1 Configure a virtual loop on the system using LD 97.
For more information, see Software Input/Output: Administration
(553-3001-311).
2 Configure the IP Phone 2001 on the system using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
3 Connect the IP Phone 2001 components:
a. Connect one end of the handset cord to the handset jack on the back
of the telephone identified with a handset icon.
b. Connect the other end of the handset cord to the handset.
4 Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the telephone (identified with a LAN icon, see
Figure 3 on page
into the IP network.
February 2005
End of Procedure
32). The other end of the CAT5 Ethernet cable plugs