16 Enter the following information provided by your system administrator:
Screen prompt
Password
Node
TN
The IP Phone 2004 registers with the TPS and if needed, begins the
firmware download. This takes several minutes. When complete, the IP
Phone 2004 resets.
Note: Port 5105 on the system must be explicitly open to enable
firmware download. For more information, refer to IP Line: Description,
Installation, and Operation (553-3001-365).
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labelling keys also appear.
17 Check for dial tone and the correct DN above the display.
18 Secure the telephone footstand to the base of the telephone. Use the
angle adjustment grip on the top back of the telephone to adjust the
position.
19 (Optional) Customize the feature keys as required. For more information,
see IP Phone 2004 User Guide.
Procedure 19
Installing an IP Phone 2004 for the first time using DHCP
1
Configure a virtual loop on the system using LD 97.
For more information, see Software Input/Output: Administration
(553-3001-311).
2
Configure the IP Phone 2004 on the system using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
3
Connect the IP Phone 2004 components:
Nortel Networks IP Phone 2004
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been configured
in your system.
The node ID.
The TN or VTN.
End of Procedure
IP Phones
Description, Installation, and Operation
Page 97 of 302