Nortel 2001 Installation And Operation Manual page 38

Page 38 of 302 Nortel Networks IP Phone 2001
553-3001-368 Standard 4.00
— the S2 node IP address of the IP line node
— the S2 action
— the S2 retry count
b. If you select Partial DHCP, then you must enter the following
parameters:
Screen prompt
S1 IP
S1 Port
S1 action
S1 retry
S2 IP
S2 Port
S2 action
S2 retry
Cfg XAS?
(0-No,1-Yes)
Note: The IP Phone 2001 can support a primary (S1) and secondary
(S2) connect server. If you require IP Phones to register on multiple
nodes, refer to "Enhanced Redundancy for IP Line Nodes" in IP Line:
Description, Installation, and Operation (553-3001-365).
After the Partial or Full DHCP steps are completed, the VLAN option
appears on the display.
9 Select either 1-Yes or 2-Au to enable 802.1Q from the DHCP Enabled -
VLAN Options menu.
Screen prompt
0-No
February 2005
Description
the node IP address of the IP line node
this is a fixed value: 4100
this is a fixed value: 1
the number of times the IP Phone 2001
attempts to connect to the server; enter 10
same as S1 in most cases (see note below)
same as S1
same as S1
same as S1
enter 0 (for No), since External Application
Server is not supported on the IP Phone
2001
This prompt exists to support future
implementation of External Application
Server.
Description
802.1Q remains off and initialization continues.
0-No is the default value.
If this is selected, proceed to step 14 to
continue the IP Phone 2001 configuration.