Nortel 2001 Installation And Operation Manual page 60

Page 60 of 302 Nortel Networks IP Phone 2002
553-3001-368 Standard 4.00
Go to Procedure 11, "Installing an IP Phone 2002 for the first time using
DHCP" on page 65.
Dynamic IP address assignment — Full DHCP
For a full DHCP installation, all parameters (IP Phone IP address, subnet
mask, default Media Gateway, Connect Server IP address, port number,
action, and retry count) are retrieved from the DHCP server to recognize the
IP Phone 2002.
The IP Phone 2002 password, node ID, and TN must be entered manually
from the key pad.
For more information on how to set up DHCP servers for use with the IP
Phones, refer to Data Networking for Voice over IP (553-3001-160).
Go to Procedure 11, "Installing an IP Phone 2002 for the first time using
DHCP" on page 65.
Procedure 10
Installing an IP Phone 2002 for the first time
1 Configure a virtual loop on the system using LD 97.
For more information, see Software Input/Output: Administration
(553-3001-311).
2 Configure the IP Phone 2002 on the system using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
3 Connect the IP Phone 2002 components:
a. Connect one end of the handset cord to the handset jack on the back
of the telephone identified with a handset icon.
b. Connect the other end of the handset cord to the handset.
4 Choose one of the following connections:
a. For a telephone not sharing LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the telephone (identified with a LAN icon, see
February 2005