Nortel 2001 Installation And Operation Manual page 68

Page 68 of 302 Nortel Networks IP Phone 2002
553-3001-368 Standard 4.00
a. If local power is used, plug the AC power transformer into the nearest
power outlet.
b. Ensure the correct AC power transformer is used. The voltage rating
of the transformer must match the wall outlet voltage. Refer to Table
8 on page 56. Connect the power jack as shown in Figure 6 on
page 61. Be sure to thread the cord around the retaining hook to
provide strain relief for a secure power connection.
6 When the Nortel Networks logo appears on the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt DHCP Yes/No?, select Yes.
8 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Phone 2002 IP address
— a subnet mask
— the default Media Gateway for the IP Phone 2002 on the LAN
segment to which it is connected
— the S1 node IP address of the IP line node
— the S1 action
— the S1 retry count (This is the number of times the IP Phone
attempts to connect to the server.)
— the S2 node IP address of the IP line node
— the S2 action
— the S2 retry count
— the External Application Server (XAS) IP address
b. If you select Partial DHCP, then you must enter the following
parameters:
Screen prompt
S1 IP
S1 Port
S1 action
February 2005
Description
the node IP address of the IP line node
this is a fixed value: 4100
this is a fixed value: 1