Nortel 2001 Installation And Operation Manual page 31

For more information on how to set up DHCP servers for use with the
IP Phones, refer to Data Networking for Voice over IP (553-3001-160).
Go to Procedure 3, "Installing an IP Phone 2001 for the first time using
DHCP" on page 36.
Procedure 2
Installing an IP Phone 2001 for the first time
1 Configure a virtual loop on the system using LD 97.
For more information, see Software Input/Output: Administration
(553-3001-311).
2 Configure the IP Phone 2001 on the system using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
3 Connect the IP Phone 2001 components:
a. Connect one end of the handset cord to the handset jack on the back
of the telephone identified with a handset icon.
b. Connect the other end of the handset cord to the handset.
4 Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the telephone (identified with a LAN icon, see
Figure 3). The other end of the CAT5 Ethernet cable plugs into the IP
network.
Nortel Networks IP Phone 2001
IP Phones Description, Installation, and Operation
Page 31 of 302