Table of Contents
Advertisement
NOTE
Front Panel Operations
Making Measurement
To Measure DC Current/Voltage
The following procedure performs DC current or voltage measurement using the
specified measurement and source channel.
1. Press the
key repeatedly to specify the source and measurement channel.
OutCh
The channel number must appear in the S-ch status area.
2. Confirm that the Output status indicator does not show the output enable status.
If the source output has been enabled, press the
source output.
3. Press the
key repeatedly to specify the source and measurement
MeasCh
channel. The channel number displayed in the M-ch status area must be same as
the channel number displayed in the S-ch status area.
4. Press the
MeasItem
Select Measurement Item" on page
5. Press the
MeasRange
Measurement Range" on page
6. Press the
key repeatedly to select the A/D converter operation mode. See
Integ
"To Set A/D Converter" on page
7. Change the source output value if necessary. See
Current/Voltage" on page
8. Press the
key to enable the source output. The measurement channel
On/Off
Output status must be ON to perform the measurement.
9. Press the
key to execute a spot measurement.
Single
Or press the
Repeat
To stop the repeat measurement, press the
To change the source output value or the compliance value during measurement, see
"To Set Output/Compliance Value" on page
To stop source output and measurement of the channel specified by the S-ch status,
press the
key.
On/Off
5-22
key repeatedly to select the measurement item. See
5-23.
key to set the measurement range. See
5-24.
5-25.
5-16.
key to execute repeat measurements.
Single
5-17.
Keysight E5260/E5270 User's Guide, Edition 6
key. This disables the
On/Off
"To Select
"To Apply DC
key.
"To
Advertisement
Table of Contents
