Table of Contents
Advertisement
NOTE
If You Have a Problem
This chapter explains how to solve a problem or how to read status and error codes,
if you encounter some problem, and consists of the following sections:
•
"When You Install the E5260/E5270"
This section explains how to solve the problems that may occur when installing
the Keysight E5260/E5270.
•
"When You Make a Measurement"
This section explains how to solve the problems that may occur when making a
measurement.
•
"Channel Status Code"
This section lists channel status codes that may be displayed on the LCD when
operating the Keysight E5260/E5270.
•
"Error Codes"
This section lists codes and messages of errors that may cause when operating
the Keysight E5260/E5270.
Error causes if the Keysight E5260/E5270 is not operated correctly, or it fails
self-test or calibration.
If error occurs, find solutions in the following sections and solve problems.
However, if problems still remain, perform self-test.
If the E5260/E5270 fails self-test, contact your nearest Keysight Technologies
Service Center.
When shipping the Keysight E5260/E5270 to the service center
When you ship the Keysight E5260/E5270 to the Keysight Technologies service
center, do not remove the source/monitor unit (SMU) from the mainframe, and ship
the mainframe with all SMU modules.
When you ship the Keysight E5270B used with the atto sense/switch unit (ASU),
disconnect the connection cables between the ASU and the high resolution source/
monitor unit (HRSMU), and ship the ASU, connection cables, and the mainframe.
Then do not remove any module from the mainframe. The ASU can be used with
the dedicated HRSMU. So check the serial number, and ship the proper ASU.
7-2
Keysight E5260/E5270 User's Guide, Edition 6
Advertisement
Table of Contents
